Product descriptions: INS-609HE-1 substrate is polyimide ,it canused for thermal transfer printing, also black matte coating label printing, itis professional design for printing circuit board or other electronic partsidentified with a character or barcode label.
Parameter specifications:
Product structure:
(Printed Black INK)
(Polyimide Film)
(permanent Acrylic Adhesive)
(Glassine Paper Release Liner)
Product features:
features
Test factor
Test method
Test result
thickness
Total thickness
ASTM1000 test
65±5 um
Coating thickness
20±3um
PI substrate thickness
25±3um
Adhesion thickness
20±5um
adhesion
Paste on stainless steel
Paste 20 minutes(ASTM-3330)
≥35N/100mm
Paste 24 hours(ASTM-3330)
≥42N/100mm
Paste on PCB board
Paste 20 minutes(ASTM-3330)
≥25N/100mm
Paste 24 hours(ASTM-3330)
≥40N/100mm
Holding power
AXR600W white resin ribbon
ASTM D2979 test
Poly ken probe tack 1 second, separate 1 cm per second
≥1000 g
Valid date
It can storage over 1 year at the condition of unopened at room temperature , below 27℃ and relative humidity of 60% environment.
Notes: Above samples were tested in the performance has not been printed. Below test by Zebra 90xi printer use a sample AXR600W white resin ribbon printed.
Label printed by 3:1 rate barcode ( 6 mil X width barcode), samples influenced by below environment.
Heat resistance
Temperature resistance
Bake 5 minutes in 260℃
No visible impact
Bake 5 seconds in 315℃
No visible impact
Chemical solvents resistance
Solvent resistance performance
1 part IPA,3 parts alcohol without water for 3 minutes.
No visible impact
Terpene flux 3min
No visible impact
10% sodium hydroxide solution 3min
No visible impact
100 o C in deionized water 10 minutes
No visible impact
82 o C with 99% isopropyl alcohol for 10 minutes
No visible impact
Notes:
According to MIL-STD-202G/883E standard, the sample immersed in the specified chemical solvents, then brush lightly 10 times, observe the changes of the surface.
Statement
The above data are based on our generalunderstanding of product features, for general information only, not as a Innovcustomers design and specification basis. Customers who bought this productshould be tested under actual application conditions result from the line todecide whether to apply. Innov warrants to the purchaser of its products inmaterials and good workmanship.